🌟 [ 4 ] Parting off in the lathe - Rear Tool Post #1 [ @ ]
( 1210 viewed : 70 like : 12 comments ) I have several bad experiences parting off in my Colchester Student lathe. Having found an inverted rear mounted parting tool to be successful on my smaller Myford lathe I decided to make a similar tool post for the Colchester. This video focusses on making the base plate and involves the shaper, lathe and pillar drill as well as hand scraping.
00:00 Introduction
00:10 The issue -
too much overhang of parting tool
00:45 Successful rear mounted tool post on Myford lathe
01:15 Location of rear tool post on Colchester cross-slide
01:36 Materials to make rear tool post
02:32 Facing base on shaper
04:29 Hand scraping underside of base
08:27 Scraping of lathe cross-slide to ensure good fit with tool holder
10:40 Machining edges of base on shaper
10:49 Marking out base for holes
14:54 Drilling holes
15:13 Setting up on lathe for boring and facing
19:00 Boring and facing of base
20:56 To be continued... [ 2024-10-04T14:00:07Z ] :flashminiupdate:2024-10-05 :::: Check it out >> [ 🔗 Click here 🌐 ‼️ ]
[ 4D ] Parting off in the lathe - Rear Tool Post #1 Tool [4]
Interesting Keyword >> PartingoffinthelatheRearToolPost1